FAQ - Navigation

I installed the navigation unit in another car, but the unit acts strange and doesn't stay on the road.

When you install a navigation unit in a new car, you need to reset the calibration values that were created in the previous car.
1. Go to MENU
2. Select SETTINGS
3. Select HARDWARE INFO
4. Select 3D CALIBRATION STATUS
5. Select DISTANCE and push CLEAR
6. Select SPEED PULSE and push CLEAR
7. Select CALIBRATION STATUS and push CLEAR


Should you still experience difficulties:
- Check if the GPS antenna is properly connected and if the satellite reception is OK
- Clean the navigation disc carefully (in case of scratches: replace the disc)
- Turn off the engine, take out the key and press the reset button of the navigation unit with a pointy object
- If the speed signal is connected : check the connection and the pink wire (if this is OK, disconnect it and try without the speed pulse)
- Check if the speed signal is properly connected
-For AVIC-X1, AVIC-X1R, AVIC-X1BT, AVIC-X3: check if the hideaway box is mounted in the right direction


If still not OK, contact your nearest Authorized Service Centre.
(For Benelux you have to pass via your dealer and for France contact the customer service department.) Below you'll find the link.
Links

ASC UK
ASC BENELUX
ASC FRANCE
ASC GERMANY
ASC SWEDEN
ASC NORWAY
ASC ITALY
ASC DENMARK
ASC SPAIN
ASC PORTUGAL
ASC FINLAND

Still need your question answered?

Rate this page: