VSX-817-S 7 Channel A/V Receiver with Auto MCACC and USB Host (Silver)

The RS-232 input on the receiver can be used for graphical display during the Advanced MCACC setup and to control the receiver.
Software for Advanced MCACC setup is available for download on the Pioneer website under Support -> Software downloads.

The Advanced MCACC application software allows you to view graphs of the reverb characteristics of your listening environment on a PC. It works in the same way as 'Reverb View' in 'EQ Professional' of the receiver's 'Manual MCACC' menu (see page 40 in the receiver's Operating Instructions), but the graphs are more precise and easier to understand by using a PC.
Links

MCACC PC Display software

This is possible for certain models, but not recommended. To connect standard 4mm banana plugs to the receiver, the black plugs in the middle of the speaker connector screws must first be removed. It is difficult, but they do come out. The banana plugs (see picture attached) can now beplugged directly into the speaker connector screw.
However Pioneer recommend to use bare speaker wire.

Please find the explanation in the document below.
Links

reset VSX

Please find attached a cross table with recommended amp-speaker combinations, the info is taken from the product catalogue. Different listed combinations are possible.
Because of the below remarks, it is best that you contact your local dealer to find the best speakers for your personal setup.

Some important remarks:
1. Note that the choice which speaker set you need depends mainly on:
- budget
- bookshelf or floorstand speakers
- power rating of the amplifier for a certain impedance (8/6 Ohm)
- supported frequency range (up to 20kHz is ok for normal DVD surround, but DVD Audio and SACD need support up to 100kHz

2. Concerning power rating
- when you compare power, make sure you use the same impedance rating. (ex. VSX-AX4ASi-S: 150W/8 Ohm - 180W/6 Ohm)
- in general the power rating of the amplifier and speakers should be approx. the same (so if speakers have less power, VSX may not be set at high volume otherwise the speaker might be blown).

Links

Combination

Alter the Contrast, Brightness and the Hue in the AV Parameters Menu.

Both receivers have 2 HDMI inputs.

The VSX-2016AV has 13+1 surround modes, advanced MCACC (standing waves, pc calibration, 9 ch EQ), iPod input). The VSX-1016V has 8+1 surround modes, MCACC and no iPod input. VSX-1016V only supports HDMI switching. Audio cannot be processed and sent to the speakers.

For the entire comparison, we refer you to our website.
Links

Website

It's only possible to send audio through the i.link cable, using i.link compatible devices.

This power output ( not applicable for the UK ) is typically used to connect a DVD player or such. This way, the device is switched off together with the receiver. Don't use this output to connect devices that use more than 100W (so no TV)!

It adjusts subwoofer, rear and centre speaker levels, while enhancing delay and compressing dynamic range, for greater enjoyment of cinema-like sound at low volume.

Check the Delay Control in the Av Parameters Menu.

Yes, this is possible. Select the CD Player Input Source, then press the Video Select Button to change the Video Source.

Please find enclosed an extract of the manual for more explanation.
Links

Bi-amplification

If your model has only HDMI switching, it's not possible to decode audio from HDMI input. (Applicable models: VSX-1016V, VSX-917V, VSX-1017AV).

For all other models with HDMI input:
Check the HDMI setting in the AV options menu of the receiver/amplifier:
- AMP: audio is processed and outputted by the amplifier
- THROUGH: audio is sent to the connected TV or plasma display